A bolt that is threaded into a casting is often called a ________
A) Stud B) Crest bolt C) Cap screw D) Block bolt
C
You might also like to view...
The combustion gases forcing themselves onto the piston get into the ring grooves and leave behind a(n) ____________________.
Fill in the blank(s) with the appropriate word(s).
When bending smaller sizes of conduit, an advantage can be gained by using which of the following?
a. Mechanical bending equipment b. Bending protractors c. Electric conduit benders d. Hand bends
Technician A says that at high altitudes, engines produce lower power. Technician B says that most engine control systems can compensate the air-fuel mixture for changes in altitude. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
The most important requirements for lettering on a sketch or technical drawing are legibility and ____________________.
Fill in the blank(s) with the appropriate word(s).