How often is an Eaton AMT electric shifter assembly calibrated?

A. each time the ignition key is turned off
B. each time the ignition key is turned on
C. whenever a fault code is logged
D. whenever a technician accesses the data bus


Answer: A

Trades & Technology

You might also like to view...

When the length of quick-connect precharged line sets is altered, the charge will not normally have to be altered.

Answer the following statement true (T) or false (F)

Trades & Technology

American involvement in the affairs of Latin American nations, at the turn of the century, usually stemmed from

A. the need to defend these nations against German or British economic influence and interference with American plans. B. the American desire to expand the colonial holdings and expand U.S. economic influence in Latin America. C. the fact that they were chronically in debt. D. the desire to control the flow of Latin American immigrants into the United States. E. a desire to strengthen Latin American democracy.

Trades & Technology

The conductor voltage that is dropped is a percentage of the source voltage and can be calculated by ____.

A. multiplying voltage drop by the source voltage B. adding voltage drop to the source voltage C. subtracting voltage drop from the source voltage D. dividing voltage drop by the source voltage

Trades & Technology

Technician A says that CO and HC levels should increase if the AIR hoses are pinched off. Technician B says that a defective drive belt may cause AIR system problems. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology