How and why are end-gap grinders used?
What will be an ideal response?
If the ring end-gap is smaller than specifications, it is enlarged with an end-gap grinder. The ring is placed in the tool and a small crank is turned by hand that rotates a grinding wheel to remove material from the ring.
You might also like to view...
For the circuit of Figure P3.19, write the mesh equations in matrix form. Notice the form of the [R] and [V] matrices in [R] [I ] = [V], where
Write the matrix form of the mesh equations again by using the following formulas:
rii = resistances around loop i
ri j = ? resistances shared by loops i and j
Vi = source voltages around loop i
Crossover distortion occurs as the job of reproducing the AC input signal is passed on, or “crosses over,” from one ____ to the next.
a. emitter b. terminal c. collector d. transistor
After milk is vacuumed from a cow, it is placed in a holding tank and cooled to ___°F.
A. 5 B. 10 C. 30 D. 40
When should you drain your air tanks