A welder cuts this plate into pieces that are 8.75” wide. How many whole pieces are cut? Disregard waste caused by the cuts.
ANS: 5
Trades & Technology
You might also like to view...
While checking main bearing clearance on an inverted diesel engine, the strip of Plastigage under one main shows notably more squish than the remaining mains. What does this likely indicate on this main bearing?
A. excess bearing clearance B. insufficient bearing clearance C. thrust washer is integral with this main D. worn-out section of Plastigage
Trades & Technology
What will happen in a circuit if the voltage does not change but the resistance in the circuit increases?
What will be an ideal response?
Trades & Technology
List the four main types of final drives used on FWD vehicles.
What will be an ideal response?
Trades & Technology
What are the characteristics of a salamander?
What will be an ideal response?
Trades & Technology