?For a visual inspection of a pipe weld, what is the acceptable discontinuity for overlap?

A. ?1/32 in. (0.8 mm)
B. ?1/16 in. (1.6 mm)
C. ?3/32 in. (2.4 mm)
D. ?None allowed


Answer: D

Trades & Technology

You might also like to view...

Technician A says an injector balance tester may be used to test the injectors in a port fuel injected engine for proper operation. Technician B says an injector balance tester may be used to analyze the signals to the injectors on a port fuel injected engine from the computer. Who is correct?

A. Technician A B. Technician B C. Both A and B D. Neither A nor B

Trades & Technology

The subsequent problems deal with the improved integrator circuit shown below, where: R1 = R2 = Rs = R.What is the current through R2?

A. R / Vin B. 0 C. 2R / Vin D. Vin / R E. Vin / 2R

Trades & Technology

The air bag system relies heavily upon information concerning direction of travel and severity of the ____________________ forces.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Technician A says each manufacturer uses the same speed sensors to ease diagnostics. Technician B says each manufacturer and sometimes different ABS systems use different diagnostic procedures. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology