Bend radius is typically added to a sheet metal part to relieve stress, or the tear that occurs when a portion of a piece of material is bent.
Answer the following statement true (T) or false (F)
False
Trades & Technology
You might also like to view...
List Kirchhoff's two laws of voltage and current.
What will be an ideal response?
Trades & Technology
A HEPA vacuum is a special vacuum for _____.
What will be an ideal response?
Trades & Technology
Which component on the low-voltage circuit of a residential HVAC system is NOT a load?
A. heat anticipator B. thermostat contacts C. fan relay coil D. low-pressure control
Trades & Technology
Clear water is observed dripping out from beneath the vehicle. Technician A says that is normal. Technician B says that the evaporator housing is defective and should be replaced. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Trades & Technology