A slash is used at the end of a dimension line on a manufactured part print.
Answer the following statement true (T) or false (F)
False
Trades & Technology
You might also like to view...
If a design professional decides to use an hourly rate for compensation for additional services, what four detailed cost records are required?
What will be an ideal response?
Trades & Technology
How would you go about demonstrating that nematodes are causing a problem in your turf?
What will be an ideal response?
Trades & Technology
Which is a primary safety requirement when replacing an older furnace?
A) Properly grounding the furnace cabinet B) Removing the jumper C) Relocating the thermostat D) Properly discarding used materials
Trades & Technology
Soffited ceilings are commonly found in what room?
A. bedroom B. living room C. kitchen D. dining room
Trades & Technology