PROBLEM 2.13
Rod BD is made of steel and is used to brace the axially compressed member ABC. The maximum force that can be developed in member BD is 0.02P. If the stress must not exceed 18 ksi and the maximum change in length of BD must not exceed 0.001 times the length of ABC, determine the smallest-diameter rod that can be used for member BD.
You might also like to view...
A Midwest Cooperative needs to store 15 750 gallons of a liquid chemical. They are considering two possible containers, a hollow cylinder or a hollow sphere. The wall of the sphere will need to be 6 in. thick and the wall, top and bottom of the cylinder are each 6 in. thick. Due to space limitations the height of the cylinder must be 26.0 ft.
(a) What will be the outside diameter of the cylinder required to hold the liquid chemical? (b) What will be the outside diameter of the sphere? (c) Assume the containers are made of aluminum, which container uses the most material?
Which metering device used on flooded evaporators opens when more refrigerant condenses, enabling the refrigerant to flow into the evaporator?
A) Electronic expansion valve B) High side float C) Low side float D) Automatic expansion valve
A homeowner wants to install 520 square feet of PV panels on the house and 210 square feet on the garage. The PV panels cost $21 per? square foot to buy and install. What is the cost for this system?
Fill in the blank(s) with the appropriate word(s).
When evidence of lacquering is found on a set of crankshaft main bearings, which of the following operating and maintenance practices should be examined first?
A. quality of engine lubricating oil B. quality of fuel C. frequency of oil change intervals D. frequency of bearing rollovers