Figure 10-3 In Figure 10-3, measurement data about the process variable is sent to FT401, which is a ____________________. The data is sent to FT401 by ____________________ connector.
Fill in the blank(s) with the appropriate word(s).
transmitter, a direct
You might also like to view...
A battery high-rate discharge (load capacity) test is being performed on a 12-volt battery. Technician A says that a good battery should have a voltage reading of higher than 9.6 volts while under load at the end of the 15-second test. Technician B says that the battery should be discharged (loaded) to 2 times its CCA rating). Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
When using a polishing cloth, remove a little bit of the protruding fiber at a time, until the fiber is perfectly
a. round. b. elliptical. c. flat and level. d. flat with a 45-degree angle.
Two different scales are used in measuring temperatures. These scales are called Fahrenheit (F) and ____________________ (C).
Fill in the blank(s) with the appropriate word(s).
A scale of 1:1 may also be referred to as _________________________.
Fill in the blank(s) with the appropriate word(s).