Increasing the SFPM by 50 percent over cutting speeds recommended for carbides will:
A) Decrease tool life by over 60 percent
B) Have no appreciable effect on carbide tool life
C) Have less effect on the tool life than increasing the recommended rate of feed by 50 percent
D) Decrease tool life by over 80 percent
D
You might also like to view...
A decimal fraction can be expressed as a percent by moving the decimal point ____________________ place(s) to the right.
Fill in the blank(s) with the appropriate word(s).
Explain the benefits to using plastic engine components.
What will be an ideal response?
Drive shaft critical speed refers to:
a. the minimum speed a drive shaft needs to spin to properly lubricate the universal joints b. the speed at which the drive shaft makes maximum torque c. the maximum speed the driveshaft should turn before it starts to distort d. twice the speed that maximum torque occurs at
What are the two major functions of refrigerant piping?
What will be an ideal response?