If the ratio of starter pinion teeth to ring gear teeth was 20:1 and the engine was turning at 180 RPM then the pinion must be turning at:
a. 900 RPM b. 2000 RPM
c. 3600 RPM
d. 4800 RPM
C
Trades & Technology
You might also like to view...
Describe where the barometric damper should be installed in the chimney connector
What will be an ideal response?
Trades & Technology
What can warped parts in a boiler operation lead to?
A. Hunting B. Turbine shutdown C. Loss of boiler feedwater D. Abnormal steam emissions
Trades & Technology
A slide hammer has been fitted to an injector seized in a cylinder head, but will not pull it. What should be done?
A. drive injector downward into cylinder B. heat injector with an oxy-acetylene torch C. pull cylinder head, drive injector upward D. drill and pull injector with a screw extractor
Trades & Technology
_____ are developed by selecting animals with desired traits.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology