Increasing the armature spring force in a relay will result in _____.
a. higher drop-out values
b. lower current values
c. lower drop-out values
d. lower pull-in voltage
a. higher drop-out values
You might also like to view...
If the diameter of pulley G in the accompanying figure is 2 inches and the diameter of pulley E is 8 inches, what is the ratio G:E in lowest fractional form?
A. 1/4 B. 1/2 C. 2/1 D. 4/1
A corner between structural insulated wall panels in a SIP building requires
A) a minimum of four 2-by lumber studs. B) a minimum of two 2-by lumber studs. C) a minimum of one 2-by lumber stud. D) a minimum of three 2-by lumber studs. E) no 2-by lumber studs.
What type of op-amp circuit does not typically have a feedback path connected between its output and either of its input pins?
A) A current multiplier B) An open-loop amplifier C) A comparator D) An inverter
Why is it important to cycle the furnace on and off several times when replacing a sequencer?
A) To make sure that only the heating elements are coming on and not the blower. B) To make sure the heating elements and the blower are turning on at the same time. C) To make sure the power is working correctly. D) To make sure the heating elements and the blower are switching on and off in the correct cycle.