All of these are correct EXCEPT ________
A) Air is less dense and contains less oxygen at higher altitude.
B) Forced induction reduces the effect of altitude on engine power.
C) Engines produce lower horsepower at higher altitude.
D) Engines produce higher horsepower at higher altitude.
D
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The use of a projected tolerance zone permits the use of the largest position tolerance while eliminating the risk of orientation deviation creating an interference condition. 2. A functional gage can be used to verify the projected tolerance zone. 3. A multiple single-segment position tolerance is often used where the function of a part requires a looser tolerance for the deviations of spacing and orientation of a hole pattern. 4. A composite position tolerance can only be applied to patterns of features of size. 5. A position tolerance may not be applied to irregular features of size, such as elongated holes.
Equation 14.73, shown below, accounts for system pressures that are different from the reference pressure. Which of the following correctly describes the derivation of the equation?
A. Ideal gas behavior is assumed for the system
B. The effect of pressure was quantified using Poynting correction
C. The Peng Robinson equation of state was used to calculate fugacity
D. The effect of pressure was quantified using Raoult’s Law
E. None of these
In the process of pursuing LEED rating for a project, the role of category-Integrative Process (IP)-comes
A) during design development phase. B) before or during schematic design phase. C) during construction document phase. D) during postconstruction phase. E) during construction phase.
In which of the three Allison TC10 modules is a single planetary gearset located?
A. Torque conveter module B. Input module C. Gearbox module D. Output module