Technician A says after the initial cost of purchase, CNC equipment does not cost a shop owner any additional money to operate. Technician B says CNC equipment needs periodic maintenance and calibration. Who is correct?

A. Technician A
B. Technician B
C. Both A and B
D. Neither A nor B


Answer: B

Trades & Technology

You might also like to view...

What is the weighted average cost of capital for a corporation that finances an expansion project using 40% retained earnings and 60% venture capital? Assume the interest rates are 10% for equity financing and 16% for debt financing.

What will be an ideal response?

Trades & Technology

Technician A says during shifts from second to third gear, most Torqueflite transmissions provide for a delayed release of the front bands. Technician B says a controlled-load front servo is found on most Torqueflite transmissions. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

Technician A says that cylinder block torque twist can be the result of high cylinder pressures. Technician B says that cylinder block toque twist can be the result of drivetrain forces outside of the engine. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

Which of these statements about backing a heavy vehicle is true?

a. You should back and turn toward the driver's side whenever possible. b. You should use a helper and communicate with hand signals. c. Backing is always dangerous. d. All of the above are true.

Trades & Technology