The purpose of this wall form component is to hold the forms together at the proper spacing during and after the concrete pour
A) Strongbacks B) Panel ties C) Corner locks D) Walers
B
You might also like to view...
Saturated water with a quality of 0.55 and a temperature of 120°C enters an uninsulated diffuser at a velocity of 180 m/s. The mass flow rate is 1.5 kg/s.
(a) If the water is to exit as saturated water vapor at a temperature of 120°C, with negligible velocity, determine the necessary heat transfer rate. (b) Using your model of a diffuser, determine and plot the necessary heat transfer rates for the flow to exit as a saturated substance with qualities ranging from 0.65 to 1.0. Given: Water: x1 =0.55; T1 = 120°C; V1 = 180 m/s; x2 = 1.0; T2 = 120°C; V2 = 0; m?=1.5 kg/s What will be an ideal response?
Which of the following may cause a tank to rupture?
A. Corrosion B. Scale buildup C. Underpressurization D. Overpressurization
To make an emergency stop with air brakes, using the stab braking method, you should:
a. Pump the brake pedal rapidly and lightly. b. Brake hard until the wheels lock, and then get off the brakes for as much time as the wheels were locked. c Press on the brake pedal as hard as you can, release the brakes when the wheels locked, put on the brakes again when the wheels start rolling.
Which sensor is generally considered to be the electronic accelerator pump of a fuel injected engine?
A) ECT sensor B) O2S C) Engine MAP sensor D) TP sensor