Most manufacturers specify a maximum axial play for ball joints of about ________
A) 0.003 in. (0.076 mm) B) 0.030 in. (0.76 mm)
C) 0.010 in. (0.25 mm) D) 0.050 in. (1.27 mm)
D
You might also like to view...
Sexual differences were strongly emphasized in 19th-century America because
A. frontier life necessitated these distinctions. B. men were regarded as morally superior beings. C. it was the duty of men to teach the young how to be good, productive citizens. D. the market economy increasingly separated men and women into distinct economic roles. E. women believed this emphasis brought them greater respect.
Technician A says that a good relay should measure between 60 and 100 ohms across the coil terminals. Technician B says that OL should be displayed on an ohmmeter when touching terminals 30 and 87. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Most passenger cars have a single driveshaft, but a vehicle with a longer wheel base will MOST-Likely have a:
A. two-piece drive shaft B. three-piece drive shaft C. four-piece drive shaft D. five-piece drive shaft
The ____ of a line is the direction it takes on a compass, determined by the quadrant in which it is located and the angle it makes with the north-south baseline.
A. direction B. azimuth C. bearing D. traverse