Describe the step-by-step approach to renovating a lawn

What will be an ideal response?


The step-by-step approach to renovating a lawn will vary, depending on whether an area
is being re-seeded, spot-seeded, or spot patched. Both procedures begin with a soil test
and weed control. For reseeding, you would then amend the soil with lime based on the soil test and then add fertilizer, again based on the soil test. Next, use an overseeder to
remove thatch and loosen soil as you apply the seed. Finally, roll the lawn, mulch, and
irrigate. For renovating a lawn with greater than 50 percent turfgrass, you would mow,
dethatch, and aerate prior to liming and fertilizing. You would also apply the seed with a
broadcast seeder and use a drag mat for aeration prior to using the lawn roller

Trades & Technology

You might also like to view...

In Figure 17-7, explain why Ti-202B is reading 185.5ºF.

What will be an ideal response?

Trades & Technology

When an evaporator float switch is used in the drain pan of an air conditioner or heat pump, if the drain pan fills up, the float will interrupt the low-voltage circuit to:

A) The condensate pump. B) The fan relay. C) The compressor contactor. D) The gas valve.

Trades & Technology

A polarized electrical receptacle is used for _____

a. all power tools b. three-wire power cords c. double-insulated tools d. plugs with the ground pin cut off

Trades & Technology

Low spray gun pressure results in excessive paint loss through overspray and poor flow due to high solvent evaporation before the paint reaches the surface.

Answer the following statement true (T) or false (F)

Trades & Technology