The following scales and their notations are common to mechanical drawings:
A. FULL or 1:1
B. HALF or 1:2
C. QUARTER or 1:4
D. DOUBLE or 2:1
E. all of the above
Answer: E
Trades & Technology
You might also like to view...
What is the best way to assure adequate protection for an overload unit?
What will be an ideal response?
Trades & Technology
Which one of these characteristics do an op-amp and a MOSFET have in common?
A) high voltage gain B) high current gain C) high CMRR D) high input impedance
Trades & Technology
Construction drawings cannot be ________ for accurate dimensions because of the stretching or shrinking that takes place.
A. measured B. made C. scaled
Trades & Technology
Match the pressures in psia to the correct equivalent. (Use 15 as the conversion between psia and psig.)
A. 10 psia B. 85 psia C. 8 psia D. 0 psia E. 20 psia F. 25 psia
Trades & Technology