The opposite end of the spectrum from preformed parts is ____.
A. on-the-job fitting
B. deformed parts
C. custom fabrication
D. outsourcing
Answer: C
You might also like to view...
A semicircular-sided tank is welded in the shop. The length of the tank’s bottom, shown in the figure, is 25”, and the radius is 8”. What is the area of the tank bottom, in square inches? Round the answer to the nearest whole number.
pi=3.14
Area of a Cylinder = 
Adult insects have ____________________ legs
Fill in the blank(s) with correct word
Determine the amount of rebar needed for the CMU wall in Problem 13. In addition to the rebar shown in Figure 12.24, there is one #6 rebar located at either side of the overhead doors, which extend from the bottom of the door to 16 inches above the top of the door and two #4 rebar above the doors. Allow for two inches of cover on the vertical bars. Add 8 percent for lap and waste to the horizontal bars and 30 percent for lap and waste to the vertical bars.
What will be an ideal response?
Which of the following is not one of the five phases of the design process?
A. recognize and define the problem B. generate alternative solutions - synthesize C. evaluate alternative solution ideas - analyze D. evaluate available time