The unit of measure for resistance is the ____________________.
Fill in the blank(s) with the appropriate word(s).
ohm
Trades & Technology
You might also like to view...
____ is the application of heat to the metal after welding. It is used to slow the cooling rate and reduce hardening.
A. Annealing B. Normalizing C. Preheating D. Postheating
Trades & Technology
Which of the following improper operations will not cause equipment shutdown?
A) Bypassing alarms B) Failure to respond to an alarm C) Partially opening a bypass valve around a working control valve D) Turning off air supplies to control devices
Trades & Technology
An average engine has only ____________________ inches bearing clearance.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
The dependent notation =1 inside a block and a triangle on the output indicates a(n) ________ gate
Fill in the blank(s) with correct word
Trades & Technology