The maximum possible axis offset in a runout application (circular or total) is equal to ____________________ the runout tolerance value.
Fill in the blank(s) with the appropriate word(s).
ANS:
one-half
Trades & Technology
You might also like to view...
Review drawing number 522895A0A and then answer the question.
1. Are there any revisions shown on the drawing? 2. If so, what are they?
Trades & Technology
Technician A says that horn frequency can range from 1,800 to 3,550 Hz. Technician B says that most horn circuits use a relay and the current through the relay coil is controlled by the horn switch. Who is right?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Trades & Technology
Find the inverse Laplace transform of
Trades & Technology
What is the total amount of a bill itemized as follows: compressor seal, $7.85; refrigerant, $18.33; clutch brush set, $10.10; labor, $78.50; sales tax, $2.11?
A. $114.66 B. $115.88 C. $116.89 D. $117.69
Trades & Technology