During the month your 5 technicians produced 900 hours in sales. All your technicians are paid using the flat rate system. What is the average hourly cost of labor sales for the month?
a. Tech 1 is paid $25.00 per hour and produced 195 hours
b. Tech 2 is paid $20.00 per hour and produced 190 hours
c. Tech 3 is paid $15.00 per hour and produced 185 hours
d. Tech 4 is paid $10.00 per hour and produced 190 hours
e. Tech 5 is paid $8.00 per hour and produced 140 hours
What will be an ideal response?
$16.80
You might also like to view...
What would the minimum dissolved oxygen concentration in the Ganges River be in mg/L?
The Ganges River, shown in Figure 4.66, has an annual average flow rate of 12,105 m3/s. The average temperature of the Ganges River was reported to be 24.6ºC. The Ganges has become contaminated with raw sewerage and industrial waste so that the dissolved oxygen in the river upstream of sewerage discharges is 4.6 mg/L. Suppose that the raw sewerage that is untreated flows into the Ganges at a rate of 460 m3/s, the temperature is 25ºC, and the dissolved oxygen in the sewerage stream is completely depleted (i.e. DO = 0). How would you develop a plan for improving water quality in the Ganges River? What will be an ideal response?
Discuss the different types of flowers that are typically used in floral designing
What will be an ideal response?
Last month, HighPower, which specializes in wind power plant design and engineering, made a capital investment of $400,000 in physical simulation equipment that will be used for at least 5 years, then sold for approximately 25% of the first cost. By law, the assets are MACRS depreciated using a 3-year recovery period. By how much will the sale cause HighPower’s TI and taxes to change in year 5 if the federal tax rate is 35% and the state tax rate is 6.5%?
What will be an ideal response?
What are a ball penetrator and a diamond penetrator used for?
A) A Rockwell "A" and a Rockwell "B" hardness test B) A Rockwell "C" and a Rockwell "D" hardness test C) A Rockwell "D" and a Rockwell "E" hardness test D) A Rockwell "B" and a Rockwell "C" hardness test E) None of the above