Where a position tolerance is specified at RFS and applied to a(n) ____________________, the center plane interpretation applies.
Fill in the blank(s) with the appropriate word(s).
ANS: width
You might also like to view...
Which type of material below has the same outside diameter and wall thickness as the same nominal size and schedule of steel pipe?
a. Type K copper tubing b. Type L copper tubing c. PVC pipe d. ABS pipe
What size should the combustion air openings be for a room with an 80,000 BTU/hr input furnace and a 35,000 BTU/hr water heater if the openings are opening directly into a ventilated attic and a ventilated crawlspace?
A) 115,000/1,000 = 115 sq in free area each B) 115,000/2,000 = 57.5 sq in free area each C) 115,000/4,000 = 28.75 sq in free area each D) The size is irrelevant so long as there are combustion air vents.
The symbol in the figure below indicates which of these?
A) Ground B) Capacitor C) Diode D) Battery
Stroboscopes and tachometers are used to measure:
A) Temperature. B) Air velocity. C) Rotational speed. D) Humidity.