The procedures for multi-piece rims are being discussed.Technician A says that a tire can be inflated while it ison a piece of heavy equipment if the air pressure did not fall below 80 percent of its recommended value. Technician B says that if the tire is to be filled/inflated while off the equipment, you must use a restraining device. Who is correct?

A. Technician A
B. Technician B
C. Both
D. Neither


Answer: C

Trades & Technology

You might also like to view...

?To increase the rear trim height in an electronic air suspension system, the control module:

A. ?Stops the compressor and opens the rear air spring valves. B. ?Starts the compressor and opens the rear air spring valves. C. ?Starts the compressor and opens the vent valve D. ?Starts the compressor and closes the rear air spring valves

Trades & Technology

What type of drawing shows the sequential steps within the computer or safety system?

A. Elevation diagram B. Process schematic C. Loop diagram D. Logic diagram

Trades & Technology

The difference in ____ energy between two objects is expressed by the word voltage.

a. potential b. mechanical c. chemical d. electrical

Trades & Technology

Write state equations for the circuit of Figure E-16 with the two capacitor voltages, and as the state variables and the voltage at the input, as the excitation and the voltage, as the response. Then, assuming the capacitors are initially uncharged, find the unit step response of the circuit.

Trades & Technology