When the ends, sides, or corners of an object are to be rounded, what is shown and dimensioned?

a. A radius
b. A chamfer
c. An extension
d. A counterbore


a

Trades & Technology

You might also like to view...

Using sketches and notes, explain the difference between:

a. U-value and U-factor b. U-factor and C-factor

Trades & Technology

____________________ and ____________________ can be added to increase the value of a funeral basket

Fill in the blank(s) with correct word

Trades & Technology

To safely increase the pressure in a refrigerant cylinder while charging a system, the technician should:

A) Run warm water over the cylinder. B) Heat the bottom of the cylinder with a small propane torch. C) Heat the top of the cylinder with a small propane torch. D) Immerse the cylinder in a tub of boiling water.

Trades & Technology

In which system does less refrigerant enter the cylinder for each compression cycle, requiring more horsepower for each BTU of cooling?

A) A low-condenser temperature system B) A low-evaporator temperature system C) A high-evaporator temperature system D) A high-condenser temperature system

Trades & Technology