Where a diameter is designated as a datum feature and referenced in a feature control frame at RMB, the resulting datum is a(n) ___________________.

What will be an ideal response?


ANS: axis

Trades & Technology

You might also like to view...

When an interference angle is used, which of the following would be a usual specification?

A. one degree B. two degrees C. five degrees D. ten degrees

Trades & Technology

Which of the following could cause this condition?

A reach-in refrigerator with cap tube has the following conditions: ? Subcooling is 8° ? Superheat is 30° a. Dirty or iced evaporator b. Dirty condenser c. Restricted filter drier d. Undercharge

Trades & Technology

What is the function of synchronizers in a truck transmission?

A. bring the rotational speed of two rotating components to a single speed B. locks two rotating components together C. reduce gear clashing D. all of the above

Trades & Technology

What should be inspected as part of a visual inspection of the ignition system?

A) Spark plug wires for proper routing B) Spark plug gap C) Coil polarity D) All of the Above

Trades & Technology