List the steps for flaring the end of copper tubing
What will be an ideal response?
Clamp the tubing in the flaring block with approximately 1/8 inch above the block.
Lock the spinner is in place over the tubing Put a few drops of oil on the spinner.
Turn the spinner is until the flare is formed by pressing the tubing between the spinner and the block.
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. All of the energy from wind flowing past a point can be recovered. 2. If wind speed doubles and density and area remain constant, wind power increases by a factor of eight. 3. Physical properties of the land have no effect on the speed and turbulence of the wind. 4. The 1/7 Power Law is used to extrapolate wind speed at a new height from the speed at an old height. 5. Wind turbine designs must consider speed control to prevent mechanical damage and control generator power output when the system is operating above rated speed.
Technician A says to soak the piston rings thoroughly in oil before installing them to prevent wear during initial break-in. Technician B says a bad fuel pump can trigger a knock sensor. Who is right?
A. Technician A B. Technician B C. Both technicians D. Neither technician
_____ are perfect for miniature gardens
A) ?Thyme plants B) ?Chinese maple seedlings C) ?Ivy vines D) ?Creeping lilies
Technician A says that when fifth wheel brackets are bolted to frame rails, the section modulus over that section of the frame is increased. Technician B says that installing inverted L-section reinforcements is preferred to L-section reinforcements because the section modulus is not affected. Who is correct?
A. Technician A B. Technician B C. Both A and B D. Neither A nor B