When a transistor is used as a switch, the input signal is usually applied to the
A) cathode. B) base. C) emitter. D) collector.
B
You might also like to view...
Referring to the figure shown below, technician A says that a shorted to ground circuit between the magnetic switch coil low side and the neutral start switch should cause the circuit protection device which protects the ignition switch circuit (not shown) to open and prevent the engine from cranking. Technician B says that a magnetic switch with stuck (welded) contacts will cause the cranking motor to operate with the ignition switch in the OFF position. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Tables with DFU values for fixtures can be found in _____.
a. the job specifications b. ASPE specifications c. manufacturers' brochures d. local codes
PROBLEM 3.116 The solid shaft shown is made of a steel that is assumed to be elastoplastic with and The torque is increased in magnitude until the shaft has been twisted through 6?; the torque is then removed. Determine (a) the magnitude and location of the maximum residual shearing stress, (b) the permanent angle of twist.***
Feed intake of farm animals generally ________ as environmental temperatures (e.g.,
summer) increase. A. increases B. decreases