What component of a heat exchanger is a group of fixed or parallel tubes through which process fluids are circulated?
A) Baffles
B) Tube sheet
C) Tube bundle
D) Spacer rods
Answer: C
Explanation: A) Incorrect. Baffles are partitions located inside a shell and tube heat exchanger that increase turbulent flow and reduce hot spots.
B) Incorrect. A tube sheet is a flat plate to which the tubes in a heat exchanger are fixed.
C) Correct. A tube bundle is a group of fixed or parallel tubes through which process fluids are circulated.
D) Incorrect. Spacer rods hold the tubes in a tube bundle apart so they do not touch one another.
You might also like to view...
Referring to the figure shown below, a missing terminating resistor would cause the resistance between the CAN + and CAN - pins of the 9-pin diagnostic connector with the batteries disconnected to be approximately 120 ohms.
Answer the following statement true (T) or false (F)
What type of valve can be used for mixing water in a hydronic system?
a. A two-way zone valve b. A pressure-reducing valve c. A three-way valve d. A globe valve
The MIL located on the dash display must illuminate if inferred emissions exceed 0.5 times the federal standard.
Answer the following statement true (T) or false (F)
A vehicle's oil pressure warning light is on. Technician A says that the pressure sending unit should be replaced and the vehicle re-checked. Technician B says that a mechanical oil pressure gauge should be used to check the oil pressure before replacing the sending unit. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician