How should the center tubes be located?

Review drawing number 523708C0A and then answer the question.


The front center tube: 3/8?? from the front and 10?? from the right side
The rear center tube: 3/8?? from the back and 10?? from the right side

Trades & Technology

You might also like to view...

What is the function of torque arms on a suspension system?

A. To retain axle alignment B. To control axle torque C. To adjust alignment D. All of the above

Trades & Technology

(PE) Water for Semiconductor Manufacturing Case Throughout the present worth analy­ses, the decision between seawater and groundwater switched multiple times in Examples 5.2 and 5.4. A summary is given here in $1 million monetary units.


The confusion about the recommended source for UPW has not gone unnoticed by the general man­ager. Yesterday, you were asked to settle the issue by determining the first cost, XS, of the seawater op­tion to ensure that it is the economic choice over groundwater. The study period is set by the man­ager as 10 years, simply because that is the time period on the lease agreement for the building where the fab will be located. Since the seawater equipment must be refurbished or replaced after 5 years, the general manager told you to assume that the equipment will be purchased anew after 5 years of use. What is the maximum first cost that Angular Enterprises should pay for the seawater option?

Trades & Technology

The transconductance of an OTA is proportional to

A) a constant and the voltage gain B) a constant and the bias current C) the voltage gain and the bias current D) both a and c

Trades & Technology

The mean of a set of data is found by adding the numbers in a set and dividing by the number of numbers in the set.

Answer the following statement true (T) or false (F)

Trades & Technology