Technician A says that the torque applied to the head bolts is the same as the clamping force on the gasket. Technician B says that the clamping force is the force actually applied to the surfaces of the gasket. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
B
Trades & Technology
You might also like to view...
The tool shown in this figure is a:
A. Digital volt-ohm meter B. Scan tool C. Lab scope D. Voltmeter with waveform capabilities
Trades & Technology
When is the best time of year to fertilize grass?
a. spring c. fall b. summer d. winter
Trades & Technology
The equalizer line of an externally equalized TXV is best attached _____
a. downstream of, and near, the sensing bulb b. at the inlet of the evaporator coil c. downstream of any suction line traps d. downstream of any other valves in the suction line
Trades & Technology
The high and low pass filters in a twin-T oscillator act as a
A) phase shift filter B) notch filter C) bandpass filter D) negative feedback path
Trades & Technology