Sections in construction drawings can be organized into two types: general sections, which show room or floor layouts for buildings, or ____________________ sections.
Fill in the blank(s) with the appropriate word(s).
detail
You might also like to view...
While doing a battery capacity test, rotate the load control until the ammeter reads:
A. One half the batteries cold cranking rating B. Five times the batteries voltage rating C. Three times the ampere hour rating D. Either A or C
___________________-cut gear teeth are cut at an angle from the parallel of the supporting shaft.
Fill in the blank(s) with the appropriate word(s).
Derive the equations for slope and deflection of the beam shown in Figure P7.2. Assume the moment reactions at each fixed end are as shown. Compute the deflections at points B and C. Solve by the double integration method. EI is constant for all beams.
In the circuit shown below,
(a) Find Ra = R7 || R8.
(b) Find Rb = R6 + Ra.
(c) Find Rc = R5 || Rb.
(d) Find Rd = R2 || R3.
(e) Redraw the circuit consisting of Vs, R1, Rd, R4, and Rc. Find the equivalent resistance Req
seen from the voltage source.
(f) Find the current I1 through R1, Rd, R4, and Rc.
(g) Find the voltage across R1, voltage across Rd, voltage across R4, and voltage across Rc.
(h) Find the voltage V1, voltage V2, and voltage V3.
(i) Find the currents I5 and I6.
(j) Find the voltage V4, and currents I7 and I8.
