Engine-powered generators are widely used for ____.
A. thick metal parts
B. portable welding
C. light-gauge metal joints
D. welding fabrication
Answer: B
You might also like to view...
Progressive scientific research began in the United States around the:
a. Early 1800s c. Middle 1800s b. Middle 1900s d. Late 1700s
What term describes the transfer of heat through the circulation or movement of a liquid or a gas?
A) Conduction B) Convection C) Radiation D) Calorie
Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Technician A says that outer tie rod ends should be replaced in pairs, even if only one is worn. Technician B says that inner tie rod ends should be replaced in pairs, even if only one is worn. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician