Which of the following should not be done when changing the engine fuel filters?
A. Tighten the secondary fuel filter until the rubber gasket makes contact with the filter base; then tighten and additional half turn.
B. Install the primary fuel filter and spin it on, leaving the filter loose.
C. Fill both the primary and secondary filter with fuel before installation.
D. Operate the manual hand pump located on the injection pump until fuel bubbles surround the top of the primary filter.
Answer: C
You might also like to view...
What steps should you take to properly maintain the air compressor?
What will be an ideal response?
If a conductor produces heat faster than it is dissipated, the conductor may ____________________.
Fill in the blank(s) with the appropriate word(s).
The stage of group development during which members finally begin to accept their roles
and those of others is known as the forming stage.
Indicate whether the statement is true or false.When joining rigid fiberboard duct modules, the end flaps are secured with _____
a. 1-inch staples approximately 2-1/4 inches on center b. 1-inch outward clinching staples approximately 2 inches on center c. 1/2-inch outward clinching staples approximately 2 inches on center d. 1/2-inch stainless steel staples approximately 2-1/2 inches on center