What are the seven questions you should answer during the task mapping phase of planning?
What will be an ideal response?
What kind of tooling does the robot need?How do I want the robot to move between points?Are there any obstacles for the robot to avoid?What is the robot doing at each point?What is the robot doing between each point?Are there any conditions or other factors I need to consider in the process?Is the process logical?
You might also like to view...
A tool used for checking system pressures, evacuating systems, recovering systems, and charging systems is:
A) A recovery cylinder. B) A vacuum pump. C) A digital thermometer. D) A gauge manifold.
Why is it imperative that a nut be of the same grade as the bolt on which it is used?
What will be an ideal response?
If a blower motor has seized or dragging bearings it will pull too many amps when on high. This can be checked by using a ________
A) Fused 20A jumper wire B) Disconnecting the battery C) New blower resistor pack D) Test light
The employer cannot petition OSHA at the state or federal level for a variance.