The major disadvantage of cutting with the wet saw is that _____ .
A. thin, delicate cuts are not possible
B. the masonry unit becomes soaked with water
C. it is much slower than dry cutting
D. the dust problem is increased with wet cutting
Answer: B
You might also like to view...
?What can be done to keep the spatter to a minimum when using CO2 as the shielding gas?
A. ?Use a leading gun angle with a higher shielding gas flow rate. B. ?Maintain a very short uniform arc length while welding. C. ?Make stringer bead welds with little or no weave motion. D. ?Travel at a slower speed.
The space between the top of the subject's head and the top edge of the frame is:
a. top room b. lead room c. head room d. edge room
Top level managers are most likely to need which type of skills?
a. technical b. interpersonal c. diagnostic d. conceptual e. supervisory
Which statement below is correct?
A) Turning on the low voltage primary coil induces a high voltage in the secondary windings. B) Turning off the low voltage primary coil induces a high voltage in the secondary windings. C) No voltage is induced in the primary circuit. D) No voltage is induced in the secondary circuit.