When scribing perpendicular lines, the workpiece must be:
A) Inverted
B) Set on a parallel bar
C) Turned 90 degrees
D) Left as is and the height gage used on an angle plate
C
You might also like to view...
The first step in the decision-making process is
a. the generation of alternatives. b. brainstorming. c. recognizing and defining the situation. d. being innovative. e. implementation.
Which statement regarding high voltage circuitry in HEVs is NOT correct?
A) The system is disabled when the ignition switch is off B) The system is energized when the ICE is running and the vehicle is accelerating C) The HV system is not energized when the ICE is in idle stop mode and the electrical A/C compressor is running D) None of these
A voltage signal is cycling at a fixed rate from 0 to 12 volts. The ratio of on-time relative to the period of the cycle is the ________
A) Duty cycle B) Amplitude C) Frequency D) Pulse width modulation
The major electrical loads in an induced draft hot surface ignition furnace are
A) Induced draft blower, indoor fan motor, the gas valve, the igniter B) Limit switch, fan switch, and door switch C) Sequencer, heat strips, limit switch, and circuit breaker D) Igniter, flame sensor, and gas valve