Intake charge velocity has to be ________ to prevent fuel droplet separation

A) 50 feet per second
B) 100 feet per second
C) 300 feet per second
D) 25 feet per second


Answer: A) 50 feet per second

Trades & Technology

You might also like to view...

In residential construction, conduit is most likely to be used where conductors are _____.

a. embedded in concrete b. run in walls c. run behind kitchen countertops d. installed in finished basements

Trades & Technology

PROBLEM 3.107 For the shaft of Prob. 3.106, determine (a) angle of twist at which the section first becomes fully plastic, (b) the corresponding magnitude T of the applied torque. Sketch the T-? curve for the shaft. PROBLEM 3.106 The hollow shaft shown is made of steel which is assumed to be elastoplastic with ?Y = 145 MPa and G = 77.2 GPa. Determine the magnitude T of the torque and the corresponding angle of twist (a) at the onset of yield, (b) when the plastic zone is 10 mm deep.

Trades & Technology

Many vehicles do not require chassis lubrication if they are equipped with ______

A) No grease fittings B) Low-friction suspension joints such as ball joints C) Sealed for life joints D) All of the above

Trades & Technology

Geothermal heat pumps will ____________________ heat from the Earth and transfer it to the conditioned space in the winter and ____________________ the heat that is absorbed from the conditioned space in the summer to the Earth.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology