The ____ is a decorative trim that is placed in the corner where the wall meets the ceiling.

A. cornice
B. crown
C. baseboard
D. wainscot


Answer: A

Trades & Technology

You might also like to view...

All of the following were characteristics of Henry Clay's election campaign of 1832 EXCEPT

A. overconfidence of his campaign and the National Republicans. B. a hefty and ample campaign chest of $50,000. C. a substantial advantage over President Andrew Jackson in political support from the West and the South. D. he had strong newspaper backing. E. he lost both the popular vote and the Electoral vote.

Trades & Technology

Figure P2.79 shows an aluminum cantilevered beam loaded by the force F. Strain gauges R1, R2, R3, and R4 are attached to the beam as shown in Figure P2.79 and connected into the circuit shown. The force causes a tension stress on the top of the beam that causes the length (and therefore the resistance) of R1 and R4 to increase and a compression stress on the bottom of the beam that causes the length (and therefore the resistance) of R2 and R3 to decrease. The result is a voltage of 50 mV at node B with respect to node A.

Determine the force if

Ro = 1k? vS = 12V L = 0.3m
w = 25mm h = 100mm Y = 69 GN/m2

Trades & Technology

To make a clean break in cast iron pipe, it is best to use a _____

a. hammer and cold chisel b. snap cutter c. chainsaw d. hacksaw

Trades & Technology

The movement of force, in pounds, over a distance is _____

a. work b. energy c. pressure d. fluid power

Trades & Technology