A calculator is set in the Engineering mode. The display shows: 56.345 -03. Express this value in the proper engineering units.
A. 56.345 micro
B. 56.345 milli
C. 5.6345 milli
D. 563.45 milli
Answer: B
You might also like to view...
The term MOST-Likely used to describe anything that spins at driveshaft speed and vibrates only once every revolution is:
A. beat/boom vibration B. first order vibration C. second order vibration D. snapshot
The lower control limit LCL is best described as:
a. the highest point established as the top specification on a control chart. UCL X-bar = Average X-bar + (A2 X Average R). b. the desired value ; also called the nominal value. c. the lowest point established as the bottom specification on a control chart. LCL X-bar = Average X-bar – (A2 X Average R). d. the number of samples that are averaged together to obtain a single data point.
In the drafting room drawings are drawn to near scale.
Answer the following statement true (T) or false (F)
____ is used most frequently for underground applications--to transport water, gas, and sewage.
A. Cast iron pipe B. Steel pipe C. Stainless steel pipe D. Plastic pipe