One step in creating a multiview drawing is to mark the limit of the size of the object in all three directions. These limits define a(n) ____ space, which represents the rectilinear limits occupied by the object in each view.
A. linear
B. Cartesian
C. occupying
D. foundation
Answer: D
You might also like to view...
Describe the effect of shielded metal arc welding electrode selection on distortion.
What will be an ideal response?
?What can be done to prevent the weld bead becoming too built up when restarting a weld?
A. ?Tapering the weld down before stopping to make the restart more even. B. ?Start the next weld slightly in front of the ending point of the last weld. C. ?Make an electrode change before the rod gets too short so you see the weld better. D. ?Use a long arc on the starting electrode and hold the arc in one place so it melts the buildup down before restarting the weld.
Commercial refrigeration systems normally have:
A) A suction service valve and a discharge service valve. B) A suction service valve, discharge service valve, and a king valve. C) A liquid line valve and a suction service valve. D) Most commercial refrigeration systems do not have refrigeration service valves.
Problem 1.6 Two steel plates are to be held together by means of 16-mmdiameter high-strength steel bolts fitting snugly inside cylindrical brass spacers. Knowing that the average normal stress must not exceed 200 MPa in the bolts and 130 MPa in the spacers, determine the outer diameter of the spacers that yields the most economical and safe design.
