The recommended number of 8d finish nails used to fasten each tread to the riser below it is _____
a. two
b. three
c. four
d. five
a
Trades & Technology
You might also like to view...
Some inputs to the CVT TCM are called indirect inputs. What does this mean?
A) Sensor values are sent over the CAN bus network B) Input values are calculated, not measured C) Inputs are received via wireless transmission D) Sensor values are not that important to CVT operation
Trades & Technology
Which of the following is another term used to describe the aqueous urea solution known as DEF?
A. ammonia B. urea C. AdBlue D. dosing fuel
Trades & Technology
Which grade of fuel oil has the highest viscosity?
What will be an ideal response?
Trades & Technology
The ATM physical layer defines the:
A) interconnection rate B) type of handoff made between devices C) electrical characteristics of the signal D) interface type E) all of the above
Trades & Technology