Which of the following statements apply to CMOS devices?
A) The devices should be stored and shipped in antistatic tubes or conductive foam.
B) All tools, test equipment and metal workbenches should be tied to earth ground.
C) The devices should not be inserted into circuits with the power on.
D) All of the above are correct.
D
You might also like to view...
Which is a true statement concerning the combined CG of the crane and load?
a. If it crosses the tipping axis, the crane will tip toward the load. b. It is the difference between the weight of the crane and the weight of the load. c. It is located halfway between the CG of the crane and the CG of the load. d. The moment of the combined CG is equal to the product of the crane’s and load’s moments.
When possible, transistor casings will have some marking to indicate _____.
a. the rated voltage b. which leads are connected to the emitter, collector, or base c. the direction of current flow d. total amperage
The total timber volume produced by a stand can be increased by removing some of the trees, which is a procedure called ____
A) thinning B) managing C) ?cruising D) cropping
You have available two resistors of 100 ? and 1000 ?, two capacitors of 10 ?F and 100 ?F and one ideal operational amplifier (with its noninverting input grounded) from which to design some active filters.
(a) Draw the circuit for an active lowpass filter with a corner frequency of 159 Hz. Be sure to label the values of the resistor(s) and capacitor(s). (b) Draw the circuit for an active differentiator with the largest possible frequency response magnitude at 1 Hz. Be sure to label the values of the resistor(s) and capacitor(s). (c) Draw the circuit for an active bandpass filter. Make the low corner frequency and the high corner frequency as far apart as possible. Be sure to label the values of the resistor(s) and capacitor(s).