Given the following example of an SAE spline specification, identify the components A through D.SAE 2 1/2-10 B SPLINE(A) = SAE(B) = 2 1/2(C) = 10(D) = B
What will be an ideal response?
The note components are described as follows:
(A) Society of Automotive Engineers.
(B) The outside diameter of the spline.
(C) The number of teeth.
(D) A = a fixed nonsliding spline.
B = spline slides under no-load conditions.
C = spline slides under load conditions.
You might also like to view...
Use the following instructions to sketch the map in the space provided in Figure P4–5:
a. Use standard topographic symbols. b. Use appropriate mapping colors, unless otherwise instructed. c. North is toward the top of the page. d. The scale is 1? = 200?. e. Draw a hard-surface medium-duty road from point A to point F. f. Beginning 975? from point A, draw a bridge over a 40? wide river. g. The center of the river runs through points B, C, D, and E. h. At 420? from point A along the hard-surface road, draw an improved light-duty road to point G. i. A small creek enters the river at point C. The creek is straight and runs for 385? at a 45° angle, then turns, with a radius of 200?, approximately due north. j. North of the medium-duty road and southwest of the river, the entire area is orchard to within 200? of the river. k. The area south of the medium-duty road and west of the light-duty road is a corn crop. l. On both sides of the small creek is a grove of deciduous trees 100? wide. m. All other areas are grasslands. n. At 200? northeast of the bridge and on the north side of the medium-duty road is a forest service headquarters.
A ____ is usually replaced as preventive maintenance during a clutch job.
A. clutch hub B. clutch fork C. release bearing D. slave cylinder
Coal generates 65 percent of all the world's electricity
Indicate whether the statement is true or false
Which of the following refrigerant conversions is not considered a drop-in?
A) HFC-134a for HCFC-22 B) HCFC-409A for CFC-12 C) HFC-407C for HCFC-22 D) HCFC-123 for CFC-11