Describe the specifications of the stringer bead used to cap the weld in a cover pass.

What will be an ideal response?


The stringer bead can be continued to cap the weld. If this technique is used, the bead should overlap the pipe surface no more than 3/32 in. (2.4 mm). Total reinforcement must not exceed 3/32 in. (2.4 mm) on pipe having walls less than 3/8 in. (10 mm) thick.

Trades & Technology

You might also like to view...

Cuando se usa lona en un codo de tubo, ¿cómo se la corta?

a. Con el zigzag b. Al bies c. Con una sierra d. Contra el zigzag

Trades & Technology

While having a discussion, Technician A says that as the temperature of the engine and air under the hood increases, the evaporation rate of the fuel increases. Technician B says that with the engine running, fresh fuel is always coming into the float bowl. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

The ____________________ of the water in the soil above the pipe has an impact on lateral movement

Fill in the blank(s) with correct word

Trades & Technology

Which areas of a large office building have the most constant cooling load?

A) The north facing exterior parts of the building B) The south facing exterior parts of the building C) The interior parts of the building D) The east and west facing exterior parts of the building

Trades & Technology