To determine the piston clearance in an engine, you’ll need to measure the ____ of both the piston and the cylinder bore.
a. radius
b. diameter
c. circumference
d. area
b. diameter
You might also like to view...
Which of the following is not true of a Ford 5R55E transmission?
A. An additional gearset was added to achieve the fifth gear. B. It is an updated version of the A4LD C. It uses additional control devices for 5th gear. D. None of the above are correct.
The heat of compression can be determined using:
A) The enthalpy difference from the beginning to the end of the compressor line. B) The enthalpy difference from the beginning to the end of the condenser line. C) The enthalpy difference from the beginning to the end of the evaporator line. D) The enthalpy difference from the beginning to the end of the metering device line.
Technician A says the heated oxygen sensor monitor performs two distinct tests; one test verifies the performance of the pre- and post-oxygen sensor heater element and circuit. Technician B says the heated oxygen sensor monitor performs two distinct tests; one test monitors the pre- and post-oxygen sensor signal switch rate and signal circuit. Who is correct?
A. A only B. B only C. both A and B D. neither A nor B
How are the sheets of a multi sheet drawing numbered?
What will be an ideal response?