After a TP sensor has been tested using the MIN/MAX function on a DMM, a reading of zero volts is displayed. Which of these does this reading indicate?
A) The TP sensor is shorted
B) The TP sensor is open at one point during the test
C) The TP sensor signal is shorted to 5-volt reference
D) Both B and C are possible
B
You might also like to view...
Barometric pressure of 14.7 psi is equivalent to:
A. 1 bar B. 1 atmosphere C. 100 kPa D. All of the above
Which of the following may be part of a radial tire belt?
A) Rayon B) Nylon C) Steel mesh D) All of these are correct
Which of these locksets requires a key on both sides of the door?
a) Double-cylinder deadbolt b) Security c) Tubular d) Mortise
Technician A says that most horn circuits use a relay and the current through the relay coil is controlled by the horn switch or body control module. Technician B says that most windshield wipers use a two-brush, three-speed motor. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician