When starting a gas-powered utility tractor, set the throttle to _____
a. low idle
b. one-quarter
c. one-third to one-half
d. one-half to three-quarters
c
You might also like to view...
The figure below shows four waveforms labeled (a) to (d). Match the waveform to following signal type that is most likely:
a. Analog _____
b. Digital _____
c. Analog with noise______
d. Quantized analog ________
To lower the center of gravity when moving materials, always place the _____.
a. lightest load on the bottom b. heaviest load on the bottom c. heaviest load on top d. longest load on top
The overload contacts on a motor starter are normally open and interrupt current when an overload condition is detected
Indicate whether the statement is true or false
There is very little variation in position titles for persons employed in structural drafting at this level; the term ____ and the previously used term drafting technician are almost universal.
A. checker B. CAD technician C. CAD detailer D. CAD trainee