The size of a fillet weld refers to the length of the ____ of the weld.
A. arms
B. sides
C. legs
D. stretchers
Answer: C
You might also like to view...
Which of the following statements about the use of turnbuckles is correct?
a. Hook-and-hook turnbuckles are preferred over eye-and-eye turnbuckles for rigging. b. Turnbuckles are used to adjust the length of rigging connections. c. Turnbuckles are best tightened with a pipe wrench at least 24" (61 cm) in length. d. When using multi-legged slings or hitches, two turnbuckles should be used on each leg.
The engine speed increases when the driver depresses the accelerator pedal and releases the clutch pedal, but the vehicle does not move. Technician A says the clutch may be defective. Technician B says the dual-mass flywheel may be defective. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
On a poorly running engine the wide band oxygen sensor can be quickly checked by ________
A) Jumping the connector with a flashlight battery B) Disconnecting the vehicle battery C) Jumping the connector with a jumper wire D) Disconnecting the sensor connector
In a high pass filter, the pass band consists of frequencies below the cutoff frequency
Indicate whether the statement is true or false