Harvesting in an ice cube maker using a water spray-type coil is done using ____.
A. electric grid
B. compressor discharge gas
C. increased water flow
D. condenser air by-pass
Answer: B
You might also like to view...
A ____ is used to drive and pull nails or staples, pry boxes loose, break wallboard, and strike awls and chisels.
a. screwdriver b. hammer c. wrench d. knife
To switch from decimal to architectural units:
a. Select architectural in the Drawing Units dialog box. b. Type architectural c. Type drawing units d. Pick architectural on the status bar
AC vent temperature at the center outlet should be ________.
A) 45°F–55°F (7°C–13°C) B) 35°F–45°F (2°C–7°C) C) 55°F–65°F (13°C–18°C) D) 25°F–35°F (4°C–2°C)
In a(n) ____________________ heating system, a call for heat completes the heating control circuit, starting a chain reaction that results in lighting a burner.
Fill in the blank(s) with the appropriate word(s).